Error handling 205
Clear the errors on the printer
Remove jammed media
Introduction
If a media jam occurs, the system produces a double audio signal. The red
LEDs of the printer operator panel remain illuminated. If a jammed media
error occurs on the system, immediately remove the jammed media to prevent
damage to the printer.
The system handles the error recovery for the jammed media through a series
of dialog boxes. Use the following procedure to remove the jammed media:
How to remove jammed media
Attention: Never use a knife to cut loose the jammed media. If you use a knife
to cut loose the media, you can damage the printer.
1 Open the cover or door that the printer operator panel indicates.
2 Use a pair of scissors to cut loose the media.
3 Remove the jammed media from the output side of the printer.
To Next Page
Loading...
