Oce TCS400 - Define the Area Selection

68 Océ TCS400 User manual
Define the area selection
When to do
The Océ TCS400 scanner has an option that allows you to select an area of the
image on your original.
You can use this setting when you only need to see a specific area of the image
on the output.
Before you begin
Use the 'Area selection' settings in the Océ Settings Editor to define the default
values for the 'Area selection'.
Define the area selection
1
Select the 'Original' card with the upper softkeys.
2 Use the softkey for 'Size' to select 'Custom' as the 'Original size method'
Note: The 'Area selection' is only available when the 'Original size method' is
set to 'Custom'.
3 Set the 'Custom Width' to the correct value for the original.
4 Set the 'Custom Length' to 'Full length'.
5 Press the softkey for 'Area selection' to enter the area selection screen.
The area selection screen appears.
[24] The area selection s creen
[24] The area selection screen