Oce TCS400 - Turn on and off the Océ TCS400

Getting started 41
Turn on and off the Océ TCS400
Turn on and off the Océ TCS400
Introduction
The Océ Settings Editor application contains an important setting for the start
up and shut down of the printer and Océ Power Logic
®
controller. The path of
the setting is the following:
KO - System - Synchronize printer and Power Logic controller power
on/off.
Depending on this setting, you can turn the Océ TCS400 printer and the Océ
Power Logic
®
controller on and off, together or separately.
You can define if this setting is 'On' or 'Off'. The following paragraphs describe
how to turn on and off the Océ TCS400 when the above setting is set to either
'On' or 'Off'.
The setting 'Synchronize printer and Power Logic controller power on/off 'does
not work for the scanner. You can only turn the scanner on or off separately.
The Océ TCS400 printer and Océ Power Logic
®
controller have 2 energy save
modes that enable you to prevent unnecessary power consumption when the
system remains turned on in an idle state (see ‘Energy save modes’ on
page 44).