Oce TCS400 - Update the IT8 File for Scanner Calibration

Ensure the best quality output 149
Update the IT8 file for scanner calibration
Introduction
This section explains how to update the IT8 file which is paired to the scanner
calibration sheet.
Note: You must log on as system administrator in the Océ Settings Editor to
update the IT8 file.
When to do
The IT8 file must match the scanner calibration sheet, which is normally found
inside the front compartment of the scanner. You can find the IT8 file on the
disk supplied with the scanner calibration sheet.
If you receive a new scanner calibration sheet, replace the IT8 file on the
controller with the IT8 file received with the scanner calibration sheet.
How to update the IT8 file
1
Log on to the system administrator mode in the Océ Settings Editor.
2 From the 'Calibration' menu, select 'Scanner'.
The 'Scanner calibration' window appears.
3 Click the 'Browse' button and browse to the location of the IT8 file.
4 Select the IT8 file and click the 'Upload' button.
The system uploads the IT8 file. When the IT8 file is correctly uploaded, the
system gives a confirmation.