192 Océ TCS400 User manual
Replace the maintenance cassette
Introduction
The maintenance cassette wipes the printheads and caps the printhead nozzles.
When to do
Replace the maintenance cassette in the following situations:
■ The printer operator panel displays the message 'Maintenance cassette
nearly full.'
The print quality can deteriorate. Replace the cassette as soon as possible.
■ The printer operator panel displays the message 'Maintenance cassette full.
Press Continue to start the Replace cassette wizard.'
The Océ System Control Panel also indicates that you must replace the
cassette.
The message 'Maintenance cassette full. Press Continue to start the Replace
cassette wizard' appears.
When the maintenance cassette is full, the system produces a double audio
signal. The red LEDs of the printer operator panel remain illuminated.
Immediate action is required.
The printer operator panel displays this message after about 5000 m
2
of output.
The exact value depends on the print modes you use.
The message gives access to a wizard that contains the procedure to replace the
maintenance cassette.
When the maintenance cassette is not in position when the system starts up, the
system produces an error signal The red LEDs of the printer operator panel
remain illuminated. The printer operator panel displays the message
'Maintenance cassette not present.' The message gives access to a wizard that
contains the procedure to replace the maintenance cassette.
You can always access the wizard in the off-line mode.
To Next Page
Loading...
