Oce TCS400 - Original Release Mode

Manage jobs on the Océ TCS400 157
Original release mode
Introduction
Use the 'Original release mode' on the 'System' screen to define where originals
are held after the scan is complete.
Before you begin
Use the KO - Scanner - Settings - Original release mode setting in the Océ
Settings Editor to define the default values.
Define where originals are held after they are scanned
The 'Original release mode' has the following settings:
■ 'Hold'
The scanner holds the original at the rear after the scan is complete.
■ 'Release'
The scanner releases the original at the rear after the scan is complete.
■ 'Rewind'
The scanner rewinds and holds the original at the front side after the scan is
complete.