Manage jobs on the Océ TCS400 153
Delete or stop jobs
Delete or stop an active job on the printer
Introduction
This section describes how to delete or stop an active job on the printer. You
can delete and stop print jobs from the printer operator panel and from the Océ
Queue Manager.
How to delete or stop an active print job from the printer operator panel
1
Press the 'Stop' key on the printer operator panel.
The printer stops immediately.
A dialog box on the screen asks the user to resume or delete the job.
If you do not select an option, the printer automatically continues the printing
after 5 minutes.
2 Use the lower softkeys to indicate whether you want to resume or delete the
job.
Note: When you delete a job, the drying is not skipped. Press the key for 'Skip
drying' to cancel the drying during the drying time. When the setting KO -
Printer - Automatic media cut in the Océ Settings Editor is set to 'On', the
printer then cuts the media. If the setting is disabled, use the 'Feed & cut'
wizard to cut the output.
To Next Page
Loading...
