164 Océ TCS400 User manual
Change the type of media defined on the printer
Introduction
The standard configuration of the Océ TCS400 contains two rolls of media.
The Océ TCS400 is also available with one roll. Appendix A contains a list of
the supported media types and media sizes.
This section describes the following:
■ How to remove and load a roll of media.
■ How to change the type of media defined on the system.
When to do
Change a roll when a job needs a media type or size that is not on one of the
rolls.
Change the media type that is defined on the system if the defined media type
and the available media type do not correspond.
Before you begin
Use the KO - System - Media - Paper series setting to define the correct paper
series in the Océ Settings Editor.
To Next Page
Loading...
