66 Océ TCS400 User manual
Important copy settings
Define the size of the originals
Introduction
Define the size of the originals on the 'Original' card of the scanner operator
panel.
The following settings are available:
■ 'Automatic'
The scanner detects the size of the original based on the width of the
original.
■ 'Standard width'
TThe scanner scans only the selected standard width.
This setting overrules the automatically detected width of the original.
■ 'Custom'
The width is the width selected in the 'Original custom width' setting and
the length is equal to the length selected in the 'Original custom length'
setting.
Use this setting to scan only a part of the original.
The 'Area selection' is function is only available when you select 'Custom'
as the original width.
This setting overrules the automatically detected width of the original.
Before you begin
Use the KO - System - Media - Paper series setting in the Océ Settings Editor
to define the default paper range used when you select 'Standard' as the '
Original size method'.
To Next Page
Loading...
