Oce TCS400 - Install and Start Océ Remote Logic; Install Océ Remote Logic on Your System

Océ Power Logic® controller: Océ Remote Logic® 253
Install and start Océ Remote Logic®
Install Océ Remote Logic® on your system
Introduction
The Océ Remote Logic
®
application can run on all platforms with Java™
Virtual Machine. This section describes the installation procedures for the
different types of platforms.
Before you begin
To install Océ Remote Logic
®
on Windows
®
9.x, NT, ME, XP, or 2000, your
system must be at least equipped with a Pentium
®
233 with 32 Mb RAM.
Installation procedure for Microsoft® Windows® platforms
1
Insert the Océ Remote Logic
®
CD-ROM or the Océ Power Logic
®
controller
CD-ROM into the CD-ROM drive of your PC.
2 The installation starts automatically. If does not start automatically, run
Setup.exe.
3 Select the required language in the installation wizard and click 'OK'.
[74] Select the setup language
[74] Select the setup language
4 Follow the instructions on the screen to complete the installation of Océ
Remote Logic
®
.
Note: You can only use Océ Remote Logic
®
when TCP/IP is enabled on your
system. Refer to your system administrator for help with the installation
procedure for TCP/IP.