208 Océ TCS400 User manual
Miscellaneous errors
Introduction
This section describes the following errors:
■ The end of the media roll is reached while you print.
■ A door or cover is open although you are not in a wizard.
■ The carriage is away from its home position too long. The printheads can
become dry.
■ The media required for the job is not available on the printer.
■ Possible obstruction of ink path.
■ Excessive temperature or humidity.
■ The Océ Queue Manager contains damaged jobs that you cannot delete.
End of roll
If the setting KO - Printer - Automatic roll switch in the Océ Settings Editor
is set to 'On' and the other roll contains the same media type, the printer
automatically switches to the other roll.
If the end of the media roll is reached during printing and the other roll does
not contain the same media type, the system produces a short interrupted audio
signal. The red LEDs on the printer operator panel flash two times.
The output is dried to make retraction of the output possible.
Cover or door opened
You are only allowed to open the top cover when you are in the 'Replace
printhead' wizard.
You are only allowed to open the maintenance door when you are in the
'Replace cassette' wizard.
When you open the top cover or the maintenance door without accessing the
wizard, the system produces a warning signal. The red LEDs on the printer
operator panel remain illuminated. If you open a door or cover during printing,
the printer stops. A message on the printer operator panel tells you to close the
top cover or the maintenance door. Close the top cover or the maintenance door
to continue.
To Next Page
Loading...
