Manage jobs on the Océ TCS400 179
Overnight printing
Introduction
The Océ TCS400 has the ability to print unattended, for example outside office
hours. To use this option, the setting KO - Printer - Calibration - Overnight
printing in the Océ Settings Editor must be enabled.
When the setting 'Overnight printing' is enabled, the system will automatically
perform checks, alignments and calibrations to ensure a consistent output
quality.
Substantial changes of the temperature or the humidity can have an adverse
influence on the print quality. Use the setting KO - Printer - Climate
dependent alignment to define if the system must automatically do an
alignment when a large change in climate occurs.
Use of overnight printing
The setting 'Overnight printing' has the following options:
■ 'Check'
The system checks for failing printhead nozzles.
■ 'Check and optimize'
The system checks for failing printhead nozzles and corrects the alignment.
Use the KO - Printer - Calibration - Overnight printing check interval
setting to define the number of prints after which the system automatically
does a check or calibration.
■ 'Off'
The system will not do a calibration or check.
Calibration is only possible when one of the following media types are loaded
on the system.
■ Standard paper
■ Premium coated paper
■ Bond
■ Coated bond
■ Matte photo paper
■ High gloss photo paper
■ Deluxe bond.
If these media types are not available on the system, calibration is delayed until
the next time a print is made on one of these media types.
To Next Page
Loading...
