Oce TCS400 - Delete or Stop a Job on the Scanner

Manage jobs on the Océ TCS400 155
Delete or stop a job on the scanner
Introduction
This section describes how to delete or stop a job on the scanner. The location
where you delete or stop a job from depends on the type of job and on where
the job is in the system.
You can delete or stop a copy from the following locations in the system.
■ When you scan an original, delete or stop a copy job from the scanner
operator panel. The scanner stops.
■ When a copy job is in a queue on the Océ Queue Manager application,
delete or stop the copy job in the Océ Queue Manager. Delete or stop the
copy jobs in the Océ Queue Manager with the same method you use to
delete or stop the print jobs. (see ‘Delete or stop an active job on the printer’
on page 153). The copy jobs have a special indication on the Océ Queue
Manager.
■ When the printer prints a copy job, delete or stop the copy job from the
printer operator panel. Delete or stop the copy jobs from the printer operator
panel with the same method you use to delete or stop the print jobs. (see
‘Delete or stop an active job on the printer’ on page 153)
You can only stop a scan-to-file on the scanner.
How to delete or stop an active job from the scanner operator panel
1
Press the red ' Stop' key.
The original transport on the scanner stops immediately.
When the printer processes a copy job, the printer stops.
2 A dialog box on the screen asks the user to remove the original.
3 Use the softkeys for 'Forward' or 'Rewind' to remove the original from the scan
area.
When you have removed the original, the system is ready to start the next job.