Oce TCS400 - Log on to the Controller Applications

264 Océ TCS400 User manual
Log on to the controller applications
User modes
The Océ Power Logic
®
controller contains the following user modes:
■ Key operator
■ Repro operator
■ System administrator
■ Service operator.
Chapter 1 contains more information about the types of users (see ‘The Océ
TCS400 users’ on page 13). Chapter 9 contains more information about the
user modes in the Océ Settings Editor (see ‘Introduction to the Océ Power
Logic® controller: Océ Settings Editor’ on page 218). Log on to the correct
user mode in the Océ Settings Editor to change the key operator settings or the
system administrator settings.
Only assigned operators are allowed to use the user modes. Different
passwords are required to access the user modes.
You do not need a password for the anonymous user mode.
Passwords
■ The default password for the system administrator is SysAdm.
■ The default password for the key operator is KeyOp.
■ The default password for the repro operator is ReproOp.
If a user is logged on, the user can change the password for the current user
mode. (see ‘Change the password’ on page 263)
Note: The passwords are case sensitive.
Authorization
Only one key operator, system administrator or repro operator at a time is
authorized to change the settings.
An error message appears when a second user tries to log on to the key operator
mode or system administrator mode.
There is no limitation of users authorized to view the settings.