72 Océ TCS400 User manual
Define the scale settings
Introduction
Define the scale settings on the 'Layout' card of the scanner operator panel.
Define the scale settings
1
Select the 'Layout' card with the upper softkeys.
2 Select the 'Scale' setting with the softkey for 'Scale'.
Select one of the following:
■ 'Automatic'
The image is scaled automatically to fit exactly on the media width selected
on the 'Output' card.
■ '1:1'
The image on the output has the exact size of the image on the original.
■ Custom.
You can define a scale factor in a range from 10% to 1000%.
When the result of the scale factor is larger than the output size, loss of
information occurs.
Use the automatic scaling setting
1
Select 'Automatic' with the softkey for 'Scale' on the 'Layout 'card .
2 Define the width with the softkey for 'Media width' on the 'Output' card.
When the width is defined as 'Automatic', a '1:1' copy is made.
When the width is defined as 'Roll width', the image fits exactly on the media
roll selected on the 'Output' card.(see ‘Define the output settings’ on page 70).
When the width is defined as a standard size, the image on the output is printed
in the standard size selected. For example, if the original size was A3 and the
'Media width' selected was A1, the image on the output has an A1 size.
To Next Page
Loading...
