Oce TCS400 - Introduction to Error Handling

204 Océ TCS400 User manual
Introduction to error handling
This chapter describes what to do if an error occurs on the Océ TCS400.
The following types of errors can occur on the Océ TCS400 printer:
■ A media jam
■ A system error
■ A permanent error
■ The end of the roll of media is reached while you print
■ A door or cover is open, although you are not in a wizard
■ The carriage is away from its home position too long
■ The media required for the job is not available on the printer
■ The Océ Queue Manager contains damaged jobs that you cannot delete
The following types errors can occur on the Océ TCS400 scanner:
■ An original jam
■ A system error
■ A permanent error
■ A smartcard error (see ‘Correct smartcard errors’ on page 216)
■ An adjustment error (see ‘How to adjust the pressure platen to the thickness
of your original’ on page 159)
■ A calibration error (see ‘Calibrate the scanner’ on page 146).