Oce TCS400 - Configure the Network Settings of the Océ TCS400

Getting started 49
Configure the network settings of the Océ TCS400
Introduction
The system administrator is responsible for installing and configuring the Océ
TCS400 in the network environment. There are two ways to configure the
network settings.
■ From the printer operator panel
The off-line screen on the printer operator panel contains a wizard to
configure the network settings.
■ With the system administrator settings (SA settings) in the Océ Settings
Editor.
The Océ Settings Editor allows you to configure a large number of system
settings. Only the system administrator is authorized to define the system
settings.
Actions in the Configure system wizard
You can perform the following actions in the 'Configure system' wizard.
■ Enable DHCP for adapter 1, 2 or 3
■ Set the IP address for adapter 1, 2 or 3
■ Set the IP subnet mask for adapter 1, 2 or 3
■ Set the default gateway for adapter 1, 2 or 3
■ Clear the set memory (see ‘Miscellaneous errors’ on page 208).
Use this option for a damaged job that you cannot delete in the Océ Queue
Manager.
The 'Configure system' wizard also contains installation settings and service
settings. A password protects the installation settings and the service settings.
Only Océ service engineers can access the installation settings and the service
settings.