94 Océ TCS400 User manual
Define the scale settings
Introduction
Define the scale settings on the 'Layout' card of the scanner operator panel.
Define the scale settings
1
Select the 'Layout' card with the upper softkeys.
2 Select the 'Scale' setting with the softkey for 'Scale'.
Select one of the following:
■ 'Automatic'
The image is scaled automatically to fit exactly on the media width selected
on the 'Output' card.
■ '1:1'
The image on the output has the exact size of the image on the original.
■ Custom.
You can define a scale factor in a range from 10% to 1000%.
When the result of the scale factor is larger than the output size, loss of
information occurs.
Use the automatic scaling setting
1
Select 'Automatic' with the softkey for 'Scale' on the 'Layout 'card .
2 Select a standard size with the softkey for 'Size' on the 'Layout' card.
3 The image scales to the output size you selected. For example, if the original
size was A3 and the output size selected was A1, the image on the output has
a A1 size.
To Next Page
Loading...
