Oce TCS400 - Define the Scan-To-File Settings on the Scanner Operator Panel

82 Océ TCS400 User manual
Define the scan-to-file settings on the scanner operator panel
Introduction
This section describes how to change the default settings for the scan-to-file
jobs.
Before you begin
Define the default values of the settings in the Océ Settings Editor. See the
on-line help in the Océ Settings Editor about how to define the default settings.
How to define the scan-to-file settings
1
On the home screen, press lower softkey for 'Entry to the scan-to-file settings'
to enter the settings screen.
2 Select a card with the upper softkeys.
3 Change the settings with the lower softkeys.
4 Use the arrow keys to define the settings, or the options within the settings, that
use a spin box.
A number of settings have more options than the screen can display. A number
of other settings have numeric values. Use the arrow keys to select the options
the screen cannot display. Use the arrow keys or the numeric keys to enter the
numeric settings.