156 Océ TCS400 User manual
Handle the originals on the scanner
Feed the original
Introduction
Use the following methods to feed the original:
Before you begin
Set the 'Auto feed' setting on the 'System' screen.
The 'Auto feed' setting determines the method to feed the original.
■ 'Auto feed' is enabled.
When the original is inserted, the original is fed through the scanner. Before
you feed the original, make sure you first define the correct job settings.
■ 'Auto feed' is not enabled.
When the original is inserted, the original is fed into the scanner. After you
define the correct settings, press the green 'Start' key to feed the original
through the scanner.
How to feed the original
1
When 'Auto feed' is enabled, first define the job settings.
2 Feed the original face down.
3 Align the original on the measurement ruler.
The original feed table has a measurement ruler. The measurement ruler has
two sides. The metric measurements are found on one side, the imperial
measurements are on the other side.
The regular standard sizes for the original feeding are marked below the ruler.
4 If 'Auto feed' is not enabled, define the job settings and then press the green
start key.
After you insert the original, you can measure the original size with the ruler
printed on the pressure platen.
5 The original is fed into the scanner. The printer starts.
6 Collect the output from the printer.
To Next Page
Loading...
