64 Océ TCS400 User manual
Create and start a copy job
Introduction
This section describes a general workflow for the copy jobs on the scanner. The
Océ TCS400 scanner can do the following types of copy jobs.
■ Single sheet
■ Set.
Make sure that you define the correct input mode on the scanner operator panel
(see ‘The copy settings’).
How to create and start a single sheet job
1
Place the original face down, center aligned along the measurement ruler. If
you feed the original, keep the original in position until it is drawn into the
scanner.
2 On the home screen, select the 'Entry to the copy settings'.
3 Define the job settings on the screen. Use the upper softkeys to select the
setting card and use the lower softkeys to define the settings in the cards.
4 On the 'Input mode' section of the 'Original' card, select 'Single sheet'.
5 On the 'Media' section in the 'Output' card select the required media.
6 Use the numeric keys to define the number of copies.
If the 'Start' key is not pressed before the end of the 'Panel time-out', as defined
in the Océ Settings Editor, all settings return to their default values.
7 Press the green 'Start' key to start the copy job.
Your original is fed into the scanner. The copying starts.
Note: Make sure you first define the settings before you feed the original.
8 When the original is held at the front side or the back side, use the release
original key on the scanner operator panel to remove the original. (see ‘The
scanner operator panel’ on page 32).
Note: Use the KO - Scanner - Settings - Original release mode setting in the
Océ Settings Editor to define the 'Original release mode'. (see ‘Original
release mode’ on page 157).
9 Use the home key to return to the home screen. (see ‘The scanner operator
panel’ on page 32).
To Next Page
Loading...
