Oce TCS400 - Page 163

Manage jobs on the Océ TCS400 163
4 The screen displays the message 'Select roll for Feed & cut.' Use the lower
softkeys to select a media roll to clean cut.
5 Press the key for 'Next' to continue. The screen displays the message 'Cut?'
6 Use the lower softkeys to select the cut length option. Select one of the
following:
■ 'Yes, long strip'
Feeds the media with a full roll rotation feed (20 inches) before the printer
cuts the media.
■ 'Yes, short strip'
The printer automatically cuts the media with the least possible media waste
(8 inches).
7 Press the key for 'Finish' to confirm the settings. The screen displays the
message 'Cutting sheet...'.
After the sheet is cut, you automatically exit the wizard.