Oce TCS400 - Page 162

162 Océ TCS400 User manual
3 Press the softkey below the 'Feed & cut' card to enter the wizard.
The screen displays the message 'Preparing Feed & cut...'. The system prepares
for the feed and cut. This can take between 0 and 20 seconds.
4 Press the key for 'Feed' to feed the output in steps of 2 inches.
5 Press the key for 'Cut' to cut the output.
If you do not need to cut the output, press the key for 'Finish' to return to the
on-line screen.
After you select 'Cut', the system returns to the on-line menu.
How to use the Feed & cut wizard to clean cut a roll of media
1
Press the on-line / off-line key to set the printer off-line.
2 Use the upper softkeys to scroll to the 'Feed & cut' card.
3 Press the softkey below the 'Feed & cut' card to enter the wizard.
■ If multiple rolls are available on the system, the screen displays the message
'Select roll for Feed & cut.'
■ If one roll is available on the system, the wizard moves directly to the 'Cut?'
screen.