Oce TCS400 - Page 69

Make copy jobs on the Océ TCS400 69
6 Use the 'Selection type' setting to define the following
■ 'Delete area'
Delete the selected area from your output.
The area is grayed out on the output.
■ 'Keep area'
Keep the selected area but delete the area that was not selected.
The complete image on the output is grayed out, except the selected area.
■ 'Off'
The 'Area selection' setting is not active.
7 Use the settings 'Horizontal offset' and 'Vertical offset' to define the location of
the area.
8 Use the settings 'Width' and 'Length' to define the size of the area.
Note: Turn the original face up to measure the offset and the size of the area.
9 Use the softkey for 'Back' to return to the 'Original' card.