Oce TCS400 - Page 74

74 Océ TCS400 User manual
Define the position of the image on the output
1
Select the 'Layout' card with the upper softkeys.
2 Select the 'Horizontal align' setting with the softkey for 'Align'.
Use the arrow keys to select one of the following.
■ 'Right'
The image is put on the right margin.
■ 'Left'
The image is put on the left side margin.
■ 'Centre'.
The image is put in center of the output.
3 Select the 'Vertical align' with the softkey for 'Align'.
Use the arrow keys to select one of the following.
■ 'Top'
The image is put on the top of the output.
■ 'Bottom'
The image is put on the bottom of the output.
■ 'Centre'.
The image is put in the center of the output.
4 Select the 'Horizontal shift' setting with the softkey for 'Shift'.
■ A negative is a shift to the left
■ A positive value is a shift to the right.
5 Select the 'Vertical shift' setting with the softkey for 'Shift'.
■ A negative is a shift to the bottom
■ A positive value is a shift to the top.