Oce TCS400 - Page 257

Océ Power Logic® controller: Océ Remote Logic® 257
Use command line parameters to start the applications
Six command line parameters are available to facilitate the start of the
applications.
■ configfile=<config_file>
Sets the configuration file to use.
■ server=server
Sets the indicated server as the server to connect to.
■ language1=lang
Specifies the first language in combination with the parameter
country1=country.
■ country1=country
Specifies the first language in combination with the parameter
language1=language.
■ language2=lang
Specifies the second language in combination with the parameter
country2=country.
■ country2=country
Specifies the second language in combination with the parameter
language2=language.
Note: Always use a matching combination of language and country (see the
following table).