Oce TCS400 - Page 139

Ensure the best quality output 139
The colored lines
are not well
aligned or
blurred
Quality check
print
■ Use the 'Lines & text' content mode
■ Use the 'Presentation' quality mode
■ Use the 'Optimize print quality'
wizard to correct the problem.
■ If failing printheads cause this
problem, use the 'Replace printhead'
wizard to replace the failing
printheads (see ‘Replace a defective
printhead’ on page 186).
Missing sections
in lines or
stepped lines
Quality check
print
■ Use the 'Lines & text' content mode
■ Use the 'Presentation' quality mode
■ Use the 'Optimize print quality'
wizard to correct the problem.
■ If failing printheads cause this
problem, use the 'Replace printhead'
wizard to replace the failing
printheads.
Missing parts of
characters
Quality check
print
■ Use the 'Lines & text' content mode
■ Use the 'Presentation' quality mode
■ Use the 'Optimize print quality'
wizard to correct the problem.
Ink saturation
causes the media
to cockle
Demo print
■ Use the 'Area fills' content mode
■ The media type defined on the printer
must be the same as the media
available on the printer. If the media
type defined on the printer is not the
same as the media available on the
printer, use the 'Change media type'
wizard to change the media type
■ Use coated media.
■ Use the default drying time.
■ Use the setting KO - Printer -
Climate dependent alignment to
define if the system must
automatically do an alignment when a
large change in climate occurs.
■ Remove the printer from areas of high
humidity.
Problem Method of
analysis
Solutions