198 Océ TCS400 User manual
How to clean the scan area
Attention: Do not use abrasives, acetone, benzene or fluids that contain these
chemicals: Do not spray liquids directly on the scanner.
1 Turn off the scanner and disconnect the power plug.
2 Open the scanner cover to expose the pressure platen.
3 Remove the pressure platen.
Use one hand to press down on the platen.
Put two fingers in the openings on the front of the slider. Move the slider
toward the center until the pressure platen disengages.
[60] Use one ha nd to p ress down on the pl aten. Put two fin gers in the openi ngs on the front of the slider. Move the slider toward the ce nter unti l the pr essure pl aten disengages
[60] Use one hand to press down on the platen. Put two fingers in the openings on the front of
the slider. Move the slider toward the center until the pressure platen disengages
To Next Page
Loading...
