30 Océ TCS400 User manual
Use the upper softkeys to scroll through the wizard cards. You can select the
following wizards:
1 'Feed & cut'(see ‘Cut the output and clean cut a roll of media’ on page 161)
2 'Change media type'(see ‘Change the type of media defined on the printer’ on
page 164)
3 'Optimize print quality'(see ‘Use the Optimize print quality wizard’ on
page 141)
4 'Replace printhead'(see ‘Replace a defective printhead’ on page 186)
5 'Replace cassette'(see ‘Replace the maintenance cassette’ on page 192)
6 'Replace ink tank'(see ‘Replace the ink tanks’ on page 183)
7 'Display counters'
Select this wizard to check the amount of media and ink that is used since the
system was installed. Press the softkey for 'Finish' to return to the off-line
screen.
8 'Configure system'(see ‘Configure the network settings of the Océ TCS400’ on
page 49)
9 'Language' (switch only).
The screen of the off-line mode contains the following parts:
[3] The parts of t he off-line screen
[3] The parts of the off-line screen
Part Function
Card The cards show the names and a graphical representation
of the wizards.
Navigation Use the upper softkeys to navigate through the cards and
through the wizards. Use the lower softkeys to select a
card or options within the wizards.
To Next Page
Loading...
