Get to know the Océ TCS400 35
The upper left corner of the screen displays the system information. The
system information is not available in the following situations:
■ During a wizard
■ The screen displays an error recovery screen.
The keys
The keys on the scanner operator panel have the following functions:
■ The numeric keys.
Use the numeric keys to set numeric values. For example, the number of
copies or the scaling factors.
■ The start key
Use the start key to start the original feed. When you scan a set, press the
start key to close the set.
■ The stop key
Use the stop key to stop the scanner. When you make a direct copy, press
the stop key to stop the printer.
■ The correction key
Use the correction key to reset a setting to its default value. Press the
correction key one time to reset a setting to its default value. Press the
correction key two times to reset the numeric display to 1.
■ The home key.
Use the home key to return to the home screen. When you are in an error
recovery screen, you cannot use the home key to return to the home screen.
■ The release original key
Use the release original key to release the original from the scanner after it
is scanned.
■ The upper softkeys
Use the upper softkeys to move through the cards.
■ The lower softkeys
Use the lower softkeys to define the job settings.
■ The arrow keys
Use the arrow keys to define numeric settings.
Use the upper and lower arrow keys to increase or decrease the active value
by 1. Use the left and right arrow keys to increase or decrease the active
value by 10. Hold down the arrow keys, to rapidly scroll through the values.
When you define the scale values, use the left arrow key to move through
the reduction steps defined in the Océ Settings Editor. Use the right arrow
key to move through the enlargement steps defined in the Océ Settings
Editor. Use the arrow keys to define the settings in spin boxes.
To Next Page
Loading...
