DMTA-10026-01EN, Rev. D, January 2015
Chapter 6
106
7. Set the FOOT SWITCH to assign the button to a specific function: Q-CAL, SAVE,
SEND, or MEAS.
8. Press [MEAS] to return to the measurement screen.
Figure 6-2 The SYSTEM SETUP screen
6.3 Activating the Software Upgrade Mode
If the internal operating software of the Magna-Mike 8600 needs to be upgraded, the
user must put the instrument into the software upgrade mode prior to upgrading the
software. Software upgrade can be done using the interface program (Olympus
P/N: WINXL [U8774010]) that is included with the Magna-Mike 8600 or by using
Upgrade2010. Contact Olympus for more details concerning upgrading the software
for the Magna-Mike 8600.
To activate the Magna-Mike 8600 software upgrade mode
1. In the measurement screen, press [SET UP], and then highlight SYSTEM.
2. In the SYSTEM submenu, select UPGRADE, and then press [ENTER].
3. Once the instrument is in the UPGRADE mode, use a program on the PC, such as
WINXL or Upgrade2010, to upgrade the software on the Magna-Mike 8600.
To Next Page
Loading...
