DMTA-10026-01EN, Rev. D, January 2015
Using the Datalogger
131
• Change the current ID location to any location that already exists in the data file
for the purposes of editing that ID location.
7.5.1 Reviewing Stored Data and Changing the Active ID
You use the ID review screen to review the data in the active file.
To review stored data and change the active ID
1. Open the file that you wish to review (see “Opening a File” on page 123).
2. In the measurement screen, press [ID#], to open the ID REVIEW screen (see
Figure 7-15 on page 130):
a) Review the status flags, and measured values for the active ID.
b) Press [] to display the data for the next ID in the file.
c) Press [] to display the data for the previous ID in the file.
d) Press [ENTER], and then press [] to jump to the first ID in the file.
e) Press [ENTER], and then press [] to jump to the last ID in the file.
f) Press [ID#] to edit the ID (see “Editing the ID” on page 131).
3. Press [MEAS] to return to the measurement screen with the new active ID.
7.5.2 Editing the ID
You can edit the ID for changing the active ID to quickly jump to an existing ID. This
is useful when you are using a large database and it would take too long to locate the
desired ID using the arrow keys.
No stored data is shown while editing the ID.
To use the ID edit mode
1. Open the file in which you wish to edit an ID (see “Opening a File” on page 123).
2. In the measurement screen, press [ID#].
3. Select the ID you wish to edit (see “Reviewing Stored Data and Changing the
Active ID” on page 131).
To Next Page
Loading...
