Olympus Magna-Mike 8600 - Figure 7-4 Selecting the ID Range for the Sequential File Type; Sequential Data File Type with Custom Points; Table 15 Resulting ID Example for the SEQUENTIAL + CUSTOM File Type

DMTA-10026-01EN, Rev. D, January 2015
Chapter 7 118
Figure 7-4 Selecting the ID range for the sequential file type
7.2.4 Sequential Data File Type with Custom Points
The sequential data file type with custom points (SEQUENTIAL + CUSTOM) is
defined by a starting and an ending ID number plus a series of custom points. The
resulting file is inclusive of the start and end points and all points in between. In
addition, multiple thickness readings per ID number location are assigned using the
assigned custom points.
Use the sequential data file type with custom points for example when you want to
measure along a pipe or tube, where at each ID number location, you can take
measurements at the top, bottom, left, and right of the pipe (see an example in
Table 15 on page 118).
Table 15 Resulting ID example for the SEQUENTIAL + CUSTOM file type
START ID END ID Custom points Resulting IDs
XYZ1267 XYZ1393 TOP
BOTTOM
LEFT
RIGHT
XYZ1267TOP
XYZ1267BOTTOM
XYZ1267LEFT
XYZ1267RIGHT
XYZ1268TOP
XYZ1268BOTTOM
XYZ1268LEFT
...
XYZ1393RIGHT