Olympus Magna-Mike 8600 - Parameter Screens; Figure 2-4 the MEASUREMENT SETUP Screen

DMTA-10026-01EN, Rev. D, January 2015
Chapter 2 48
2.3 Parameter Screens
The Magna-Mike 8600 parameters are logically grouped in parameter screens that
you access using front panel keys or menu commands. Figure 2-4 on page 48 shows
the MEASUREMENT SETUP screen as an example.
Figure 2-4 The MEASUREMENT SETUP screen
The title bar, located at the top of the parameter screen, indicates the parameter
subject. One or two help text bars, appearing at the bottom of the screen, indicate the
keys to use to select a parameter and edit its value.
To select a parameter and edit its value
1. Press [] and [] to highlight the desired parameter.
2. For parameters with predefined values, press [] and [] to select the desired
value.
OR
For parameters in a list, press [] and [] to highlight the desired list item.
OR
For alphanumeric parameters, press [], [], [], and [] to highlight the desired
character, and then press [ENTER] to select the character (see “Editing Text
Parameters Using the Virtual Keyboard” on page 49 for details).
3. Highlight DONE, PREVIOUS, or NEXT, and then press [ENTER] to leave a list
or an alphanumeric parameter, and respectively go to the previous or next screen
element.
4. Press [MEAS] to exit the parameter screen and return to the measurement screen.
Help text bars
Parameters
Title bar