Olympus Magna-Mike 8600 - Figure 7-8 the FILE Menu and REPORTS Submenu; Opening a File

DMTA-10026-01EN, Rev. D, January 2015
Using the Datalogger 123
Figure 7-8 The FILE menu and REPORTS submenu
7.3.1 Opening a File
You can open an existing file to make it the active file to which new measurements
will be saved.
To open a file
1. Press [FILE], and then select OPEN.
2. In the FILE OPEN screen (see Figure 7-9 on page 124), select the file in the list that
you wish to open, and then press [ENTER].
The descriptive header for the highlighted file name appears on the lower section
of the display.
3. Select OPEN to return to the measurement screen with the selected file as the
active file and the ID number set to the first ID number in the file.