Olympus Magna-Mike 8600 - Figure 7-3 the FILE CREATE Screen for the Incremental Data File Type

DMTA-10026-01EN, Rev. D, January 2015
Chapter 7 116
To create an incremental data file
1. In the measurement screen, press [FILE], and then select CREATE.
2. In the FILE CREATE screen (see Figure 7-2 on page 114):
a) In the FILE NAME parameter, using up to 32 characters, enter the desired file
name.
b) In the DESCRIPTION parameter, optionally enter a description of the
contents of the file.
c) In the INSPECTOR ID, optionally enter an identification of the inspector.
d) In the LOCATION NOTE parameter, optionally enter an identification of
where the measurements are performed.
3. Select INCREMENTAL in the FILE TYPE field, and then enter the START ID
value (see Figure 7-3 on page 116).
4. Set the DELETE PROTECTION mode ON or OFF.
5. Select CREATE to return to the measurement screen.
Figure 7-3 The FILE CREATE screen for the incremental data file type
ABC*12*34 ABC*12*34
ABC*12*35
ABC*12*36
...
ABC*12*99
Table 13 Resulting ID examples for the INCREMENTAL file type (continued)
START ID Resulting IDs