Olympus Magna-Mike 8600 - Table 11 File Contents Summary; Table 12 Additional Information Stored with the Data

DMTA-10026-01EN, Rev. D, January 2015
Chapter 7 112
A file also contains header parameters that you can define to better describe the
content of the file. Table 11 on page 112 summarizes the contents of a file and
indicates where you can find more information.
You can identify the datalogger parameters in the ID bar at the top of the
measurement screen.
With each measurement, the Magna-Mike 8600 also stores a complete description of
the measurement conditions. Table 12 on page 112 describes the additional data
stored with each thickness measurement.
Table 11 File contents summary
Contents Description See section
Header Extra parameters to describe the contents and
the context of the data
“Creating a
Data File” on
page 113
Measurement
data
Organized by predefined IDs arranged by file
types
“Data File
Types” on
page 114
Table 12 Additional information stored with the data
For a measurement
File name
File header data
Identifier
Units (in. or mm)
LOS (loss-of-signal)
Differential mode
Differential reference value
Alarm mode
Alarm status
Alarm set points
Minimum or maximum mode
Minimum or Maximum Reading
Resolution