Olympus Magna-Mike 8600 - Alkaline Batteries; Figure 1-10 Removing the Lithium-Ion Battery

DMTA-10026-01EN, Rev. D, January 2015
Chapter 1 28
6. Install the battery compartment cover at the back of the instrument, and then
tighten the two thumb screws to complete the installation.
Figure 1-10 Removing the lithium-ion battery
1.4.3 Alkaline Batteries
The Magna-Mike 8600 has an optional battery holder (Olympus P/N: 600-BAT-AA
[U8780295]). This holder accommodates eight AA-size alkaline batteries in situations
where an AC power source is not available and the internal Li-ion battery is
discharged. When operated under typical inspection conditions, the alkaline batteries
will provide a minimum of three hours of continuous operation.
To install the alkaline battery holder
1. Unfold the instrument stand.
2. Loosen the two thumb screws securing the battery compartment cover at the back
of the instrument, and then remove the battery compartment cover.
3. Remove the lithium-ion battery, if installed (see Figure 1-11 on page 29).
Battery
compartment
cover
Thumb
screws (two)
Battery
Stand