DMTA-10026-01EN, Rev. D, January 2015
Chapter 3
54
e) Select SET to accept the changes.
OR
Select CANCEL to discard the changes.
4. Press [MEAS] to return to the measurement screen.
Figure 3-3 The CLOCK SETUP screen
3.4 Changing Display Settings
You can change the appearance of some display elements such as colors and
brightness.
To change the display setting
1. In the measurement screen, press [DISPLAY].
2. In the DISPLAY screen (see Figure 3-4 on page 55), select the desired parameter
and value for the following parameters:
•Set COLOR SCHEME to either select the INDOORS or OUTDOORS for
optimized visibility (see “Color Schemes” on page 55 for details).
•Set BRIGHTNESS to one of the predefined brightness levels: 0 %, 25 %, 50 %,
75 %, or 100 % (see “Display Brightness” on page 56 for details).
•Set VGA OUTPUT to ON or OFF.
• LARGE FONT to select which of the following measurements is displayed on
the screen in large font: LIVE (active measurement), MIN (minimum), MAX
(maximum), or DIFF (differential) value.
To Next Page
Loading...
