DMTA-10026-01EN, Rev. D, January 2015
Chapter 7
114
Figure 7-2 The FILE CREATE screen
5. Select CREATE to return to the measurement screen.
At any time, you can highlight NEXT or PREVIOUS and then press [ENTER] to jump
to the next or previous parameters on the screen.
7.2.1 Data File Types
You can create a data file using one of the following four data file types:
• Incremental
•Sequential
• Sequential with Custom Points
• 2D Matrix Grid
7.2.2 Incremental Data File Type
The incremental data file type uses the alphanumeric start ID value (up to
20 characters) and automatically increments to the subsequent ID value using the
following incrementing rules:
• Increments only digits and letters, not punctuation or other special characters.
To Next Page
Loading...
