Olympus Magna-Mike 8600 - Figure 7-6 General 2 D Grid Example

DMTA-10026-01EN, Rev. D, January 2015
Using the Datalogger 121
Figure 7-6 General 2D grid example
To create a 2D grid data file
1. In the measurement screen, press [FILE], and then select CREATE.
2. In the FILE CREATE screen (see Figure 7-2 on page 114):
a) In the FILE NAME parameter, using up to 32 characters, enter the desired file
name.
b) In the DESCRIPTION parameter, optionally enter a description of the
contents of the file.
c) In the INSPECTOR ID, optionally enter an identification of the inspector.
d) In the LOCATION NOTE parameter, optionally enter an identification of
where the measurements are performed.
3. In the FILE TYPE field, select 2D.
4. Set the DELETE PROTECTION mode ON or OFF.
5. At the bottom of the FILE CREATE screen, select CONTINUE.
6. In the second page of the CREATE screen (see Figure 7-7 on page 122):