Olympus Magna-Mike 8600 - Page 176

DMTA-10026-01EN, Rev. D, January 2015
List of Figures 166
Figure 3-1 The SYSTEM SETUP screen ............................................................................. 52
Figure 3-2 The MEASUREMENT SETUP screen — UNITS ........................................... 53
Figure 3-3 The CLOCK SETUP screen ............................................................................... 54
Figure 3-4 The DISPLAY screen .......................................................................................... 55
Figure 3-5 Example of the indoors and the outdoors color schemes ............................ 56
Figure 4-1 Standard straight probe model 86PR-1 ........................................................... 62
Figure 4-2 Right-angle head probe model 86PR-2 ........................................................... 62
Figure 4-3 Low-profile articulating probe model 86PR-3 ............................................... 63
Figure 4-4 The MEASUREMENT SETUP screen ............................................................. 67
Figure 4-5 The MEASUREMENT SETUP screen ............................................................. 78
Figure 4-6 Alignment of target ball in fixture on probe .................................................. 79
Figure 4-7 Aligning disk to chisel edge ............................................................................. 80
Figure 4-8 THIN SHIM calibration point .......................................................................... 80
Figure 4-9 THICK SHIM calibration point ........................................................................ 81
Figure 4-10 Adding additional calibration points ............................................................. 82
Figure 4-11 The MULTIPOINT CALIBRATION screen .................................................... 82
Figure 4-12 Recalling a calibration file ................................................................................ 84
Figure 4-13 Correct method for thickness measurements ................................................ 85
Figure 4-14 Inaccurate measurement due to obstruction of probe tip ............................ 86
Figure 4-15 Inaccurate measurement due to obstruction of target ball .......................... 86
Figure 4-16 Inaccurate measurement due to surface curvature ....................................... 86
Figure 4-17 Inaccurate measurement due to bad probe alignment ................................. 87
Figure 5-1 Normal differential mode ................................................................................. 91
Figure 5-2 The DIFFERENTIAL SETUP screen ................................................................ 93
Figure 5-3 Displaying the minimum and maximum thicknesses .................................. 94
Figure 5-4 The MIN/MAX screen ....................................................................................... 95
Figure 5-5 Example of a HIGH alarm indicator ............................................................... 96
Figure 5-6 The ALARM SETUP screen .............................................................................. 97
Figure 5-7 Strip chart view with and without statistics .................................................. 98
Figure 5-8 The STRIP CHART VIEW screen .................................................................... 99
Figure 5-9 Example of a locked function message in the help bar .............................. 100
Figure 5-10 The PASSWORD SETUP screen .................................................................... 100
Figure 5-11 The INSTRUMENT LOCK SETUP screen .................................................... 101
Figure 6-1 The MEASUREMENT SETUP screen ........................................................... 103
Figure 6-2 The SYSTEM SETUP screen ........................................................................... 106
Figure 6-3 The UPGRADE screen .................................................................................... 107
Figure 6-4 The COMMUNICATIONS SETUP screen — RS-232 ................................. 108
Figure 7-1 The active file name appearing in the header bar ....................................... 111
Figure 7-2 The FILE CREATE screen ............................................................................... 114
Figure 7-3 The FILE CREATE screen for the incremental data file type .................... 116
Figure 7-4 Selecting the ID range for the sequential file type ...................................... 118
Figure 7-5 Configuring the ID range for a sequential file with custom points .......... 120