Omron NX Series User Manual

Device varia-
ble
Variable Data type Name
Lists the variable names and data types for device variables that provide direct error notification, that are
directly affected by the error
, or that contain settings that cause the error.
Cause and
correction
Assumed cause Correction Prevention
Lists the possible causes, corrections, and preventive measures for the error.
Attached in-
formation
This is the attached information that is displayed by the Sysmac Studio or an HMI.
*4
Precautions/
Remarks
Provides precautions, restrictions, and supplemental information. If the user can set the event level, the
event levels that can be set, the recovery method, operational information, and other information is also
provided.
User name in
the access log
Provides the name of the user who performed the operation that generates the access log. This informa-
tion is provided only for errors (events) for which the user name is recorded in the access log.
*1. One of the following:
Minor fault: Minor fault level
Observation
Information
*2. One of the following:
System: System event log
Access: Access event log
*3. One of the following:
Continues: Execution of the user program will continue.
Stops: Execution of the user program stops.
Starts: Execution of the user program starts.
*4. Refer to Applicable Range of the HMI Troubleshooter of the
NJ/NX-series Troubleshooting Manual (Cat. No. W503) for
the applicable range of the HMI Troubleshooter.
X Bus Ethernet Function Module
This section provides detailed information on errors (events) related to the X Bus Ethernet Function
Module.
14 Troubleshooting
14-15
NX-series EtherNet/IP Unit User's Manual (W627)
14-4 Checking with the Sysmac Studio, an HMI, and Instructions That Read Error
Status
14
14-4-4 Error Details

Omron NX Series Specifications

General

Brand	Omron
Model	NX Series
Category	Controller
Language	English