EasyManuals Logo
Home>Omron>Controller>NX Series

Omron NX Series User Manual

Omron NX Series
464 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #358 background imageLoading...
Page #358 background image
Event name DNS Setting Error Event code 36080000 hex
Meaning Errors were detected in DNS setting and Hosts setting.
Source X Bus Ethernet Function Module Source details 1 to 4: Mounting
position of the X
Bus Unit (unit
number)
and
communications
port
are given in
combination
Detection tim-
ing
At power ON or
Controller reset
Error attributes Level Minor fault Recovery Automatic re-
covery (after
downloading the
settings), cycle
the power sup-
ply, or Controller
reset
Log category System
Effects User program Continues. Operation Ethernet communications are not possible.
Indicators
Ethernet NET RUN Ethernet NET ERR Ethernet LINK/ACT
OFF Flashes at 1-s intervals. ---
Device variable Variable Data type Name
ETN_DNSCfgErr BOOL DNS Setting Error
Cause and cor-
rection
Assumed cause Correction Prevention
Parameter error Identify the cause of the error from
the attached information, correct
the settings, and then download
the settings again.
None
Power interruption while download-
ing Ethernet port settings
Clear all memory or download the
settings again.
Do not turn OFF the power supply
to the Controller while downloading
the Ethernet port settings.
Memory error If the above measures do not work,
replace the Unit.
None
Attached infor-
mation
Attached information 1: Error type
01 hex: Non-volatile Memory Access Error
, 02 hex: There is an inconsistency in the set values.
Attached information 2: Error Details
00 hex: Non-volatile memory access error
If there is an inconsistency in the set values:
14 hex: Preferred DNS setting error
, 15 hex: Alternate DNS setting error, 16 hex: Illegal domain name, 17 hex:
Illegal hosts settings
Precautions/
Remarks
None
14 Troubleshooting
14-22
NX-series EtherNet/IP Unit User's Manual (W627)

Table of Contents

Other manuals for Omron NX Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron NX Series and is the answer not in the manual?

Omron NX Series Specifications

General IconGeneral
BrandOmron
ModelNX Series
CategoryController
LanguageEnglish

Related product manuals