Omron NX Series User Manual

Event name BOOTP Client Started Event code 96480000 hex
Meaning The BOOTP client started requesting an IP address.
Source X Bus Ethernet Function Module Source details 1 to 4: Mounting
position of the X
Bus Unit (unit
number)
and
communications
port 1/
communications
port 2
are given
in combination
Detection tim-
ing
At power ON or
Controller reset
Error attributes Level Information Recovery --- Log category System
Effects User program Continues. Operation Not affected.
Indicators Ethernet NET RUN Ethernet NET ERR Ethernet LINK/ACT
--- --- ---
Device variable Variable Data type Name
None --- ---
Cause and cor-
rection
Assumed cause Correction Prevention
The BOOTP client started request-
ing an IP address.
--- ---
Attached infor-
mation
None
Precautions/
Remarks
None
Event name SNMP Started Event code 964B0000 hex
Meaning The SNMP agent started normally.
Source X Bus Ethernet Function Module Source details 1 to 4: Mounting
position of the X
Bus Unit (unit
number) and
SNMP are given
in combination
Detection tim-
ing
At power ON or
Controller reset
Error attributes Level Information Recovery --- Log category System
Effects User program Continues. Operation Not affected.
Indicators Ethernet NET RUN Ethernet NET ERR Ethernet LINK/ACT
--- --- ---
Device variable Variable Data type Name
None --- ---
Cause and cor-
rection
Assumed cause Correction Prevention
The SNMP agent started normally. --- ---
Attached infor-
mation
None
Precautions/
Remarks
None
14 Troubleshooting
14-28
NX-series EtherNet/IP Unit User's Manual (W627)

Omron NX Series Specifications

General

Programming Languages	Ladder, Structured Text, Function Block Diagram, Sequential Function Chart
Communication Ports	Ethernet, USB, RS-232C, RS-485
Memory Capacity	Varies by model
Program Memory	Varies by model
Data Memory	Varies by model
Operating Temperature	0°C to 55°C
Power Supply	24 VDC
Ethernet Ports	1 or 2 ports (depending on model)
USB Ports	1 or 2 ports (depending on model)
Dimensions	Varies by model
Weight	Varies by model