Omron NX Series - Page 431

l
Transferring Only the EtherNet/IP Connection Settings
You can transfer tag sets and connections to the EtherNet/IP devices.
1 Establish an online connection with the Controller.
2 Click the Transfer to Controller or Transfer from Controller Button in the EtherNet/IP Con-
nection Setting T
ab Page.
The tag settings and connection settings set at that time are transferred to the Controller con-
nected online.
3 If the Controller connected online is in RUN mode, the dialog box to confirm whether to switch
to PROGRAM mode before transferring the settings is displayed.
l
Comparison
The differences in the tag set and connection settings between the project and the EtherNet/IP de-
vices can be displayed.
1 Click the Compare Button in the EtherNet/IP Connection Setting T
ab Page.
Appendices
A-31
NX-series EtherNet/IP Unit User's Manual (W627)
A-3 Use the Sysmac Studio to Set the Tag Data Links (EtherNet/IP Connections)
A
A-3-4 Making the EtherNet/IP Connection Settings with the Sysmac Studio