Oracle X4 series User Manual

Replicate the Oracle ILOM Firmware Configuration on Other Oracle Systems (Oracle ILOM)
set include_faultdata=true
Note - The fault data backup and restore is reserved for Oracle service personnel when
they replace the SP.
iv) To initiate the restore operation, type:
set load_uri=transfer_method://username:password
@ipaddress_or_hostname/directorypath/filename
See Also
■
Restore the Oracle ILOM Backup XML File, Oracle ILOM Configuration and Maintenance
Guide for firmware version 3.1 or 3.2.
■
Reset the Oracle ILOM Configuration to Factory Defaults, Oracle ILOM Configuration
and Maintenance Guide for firmware version 3.1 or 3.2.
Replicate the Oracle ILOM Firmware Configuration
on Other Oracle Systems (Oracle ILOM)
Use Oracle Integrated Lights Out Manager (ILOM) to enhance consistency and standardize the
service processor (SP) or chassis monitoring module (CMM) configuration on multiple Oracle
systems by: 1) capturing the configuration settings from a model server SP or CMM, and 2)
replicating the captured configuration on other server SPs or CMMs.
Before You Begin
■
Log in to Oracle ILOM. For instructions see “Launch and Log In to Oracle
ILOM” on page 39.
■
Ensure that you have the privileges associated with the following roles in Oracle ILOM:
Admin (a), User Management (u), Console (c), Reset and Host Control (r), and Read-Only
(o).
Follow these steps to replicate Oracle ILOM configuration parameters from one server SP or
CMM on other server SPs or CMMs.
140 Oracle X4 Series Servers Administration Guide • April 2016

Oracle X4 series Specifications

General

Brand	Oracle
Model	X4 series
Category	Server
Language	English