Oracle X4 series

Configure SP Network Settings (Oracle System Assistant)
Configure SP Network Settings (Oracle System
Assistant)
Before You Begin
Obtain the Oracle ILOM network information, such as DHCP settings and IP addresses.
1.
Access Oracle System Assistant.
See “Accessing Oracle System Assistant” on page 147 for details.
2.
Click Configure Hardware, and then click the Service Processor Configuration
tab.
The Service Processor Configuration screen appears.
3.
Select Network Configuration from the drop-down list.
The Network Configuration appears.
4.
Set the network settings to the desired values.
■ Enter the following values for IPv4:
a.
IP Discovery Mode
Select whether the system uses Dynamic Host Configuration Protocol (DHCP) or a
static IP assignment.
b.
IP Address
If you selected a static IP assignment, provide the IP address of the SP.
c.
Netmask
If you selected a static IP assignment, provide the netmask for the SP.
d.
Gateway
If you selected a static IP assignment, provide the gateway address for the SP.
■ Enter the following values for IPv6:
88 Oracle X4 Series Servers Administration Guide • April 2016