Navigate the BIOS Setup Utility Menus
■ Alternatively, to save your changes and exit the BIOS Setup Utility, you can
select the Save & Exit Menu and then select Save Changes and Reset.
■ Or to stop the exit process, select Cancel.
Note - After modifying any BIOS settings and selecting Save Changes and Reset from the Save
& Exit menu, the subsequent reboot might take longer than a typical reboot when no settings
were modified. The additional delay is required to ensure that changes to the BIOS settings are
synchronized with Oracle ILOM.
See Also
“Access the BIOS Setup Utility Menus” on page 190
Navigate the BIOS Setup Utility Menus
To navigate the menus or options listed on a screen, use the arrow keys. The options or fields
that you can configure on a menu appear in color.
For further instructions on how to navigate and change settings in the BIOS Setup Utility, refer
to the online navigation information provided on lower right side of the menu. The upper right
side of the menu provides information about the menu selection.
1.
Access the BIOS Setup Utility.
a.
Boot the system.
Boot messages scroll across the console screen.
b.
Press the F2 key (or Ctrl +E from a serial terminal) continuously.
The BIOS Setup Utility main screen appears.
2.
To select the different primary menu options, use the left and right arrow keys.
As you select each menu option, the top-level screen for that menu option appears.
3.
To select an option on a top-level screen, use the up and down arrow keys to
navigate the options presented.
Setting Up and Configuring BIOS 193
To Next Page
Loading...
Need help?
General
