Panasonic DP-C305 - IT Belt Replacement

228
FEB 2008Ver. 1.1
DP-C405/C305/C265
3.18. IT Belt Replacement
<Important Notice>
1. When replacing the IT Belt, clean all the Metal Rollers, such as Bias Roller, and Feed Rollers with a
soft cloth saturated with Alcohol first. Toner stuck on the Rollers will affect the Print quality, and may
reduce the life of the IT Belt.
2. When replacing the IT Belt, replace the Adjustment Bushings at the same time.
Use the Adjustment Bushings enclosed with the new IT Belt to accommodate for the belt length
variations.
3. Reinstall the Adjustment Roller, and the Snap Ring as illustrated.
4. After completing the IT Belt replacement, execute the following parameter initialization.
<Counter Reset>
Note:
When replacing the IT Belt, the STR Unit and the Cleaning Unit (120K) should be replaced at the same
time. After their replacement, perform F8-32 (STR Life Count reset).
<Color Registration>
After completing the Maintenance, perform “F8-30 Color Registration”.
For details, refer to the sections 2.2.10., 3.4., and 3.5.
Reset Counter
Maintenance
(240k)
Perform F8-29 Belt Counter Reset
"F7-02-51" is also initialized by this operation.
F7-02-51
Transfer Belt Life Count Down
Adjustment Bushing
Adjustment
Roller
IT Unit Frame
Snap Ring
1
3
2